The Meritor 25RY68-3 or 25RY683 weld yoke is a genuine Meritor driveline part in the RPL25 series. It is the end fitting that gets welded onto a driveshaft tube so a universal joint can be fitted and the shaft can carry torque. It is sized for tubing 4.59 in. across with a .180 in. wall (7 GA), has a 4.24 in. insert diameter and sits 3.70 in. from the center to the weld point. Bearing caps are 2.06 in. across and the ears span 8.33 in.
The yoke has to be properly welded into the shaft for correct operation, so the job belongs with a qualified driveshaft shop. It is listed in Meritor tube and stub yoke assemblies such as 25RHC036B060 and 25RHC028B050. Call us to confirm proper fit for your application.
Features
Genuine Meritor RPL25 series weld yoke
Use with tubing 4.59 in. x .180 in. (7 GA)
Insert diameter 4.24 in., center to weld point 3.70 in., center to end 5.00 in.
Bearing cap diameter 2.06 in., 8.33 in. across the ears
Joint angle 27 degrees, use with U-joint kit CP25RPLS1
Welded onto the shaft tube by a qualified shop for proper operation
Tech Specs
- Series: RPL25
- Bearing cap diameter: 2.06 in.
- Yoke dimension across ears: 8.33 in.
- Insert diameter: 4.24 in.
- Center to weld point: 3.70 in.
- Center to end: 5.00 in.
- Tubing OD and wall: 4.59 in. x .180 in. (7 GA)
- Joint angle: 27 degrees
- U-joint kit: CP25RPLS1
